Hydraulic Repair Schematic

Caterpillar Hydraulic

Skip to content
Menu
  • Home
  • CAT Hydraulics Troubleshooting
  • Contact Us
  • Oil & Gas Processes
  • Privacy Policy
  • Terms and Conditions

Category: Komatsu PC-01

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – Electrical circuit diagram

Posted on July 10, 2022
Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – Hydraulic circuit diagram

Posted on July 10, 2022July 10, 2022
Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – 1/6 Reduction

Posted on July 10, 2022

a. Disassembly/reassembly b. Inspection – Clutch friction disc thickness – Clutch plate warpage Check clutch plate warpage on a flat plate using a feeler gauge.…

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – 1/2 Reduction (Centrifugal clutch type)

Posted on July 9, 2022

a. Disassembly/reassembly  

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – L-Type reduction

Posted on July 9, 2022

a. Disassembly/reassembly  

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – Governor, oil level switch

Posted on July 6, 2022

a. Disassembly/reassembly b. Inspection – Oil level switch Check continuity between the yellow and green switch leads with an ohmmeter. 1) Hold the switch in…

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – Crankcase cover, crankshaft, piston

Posted on July 6, 2022

a. Disassembly/reassembly – Crankshaft bearing Reassembly: Oil the circumference of the bearing, and install the bearing with the following special tools. – Timing gear/governor drive…

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – Cylinder head, valves

Posted on July 6, 2022

a. Removal/installation b. Disassembly/reassembly c. Inspection – Valve spring free length Measure the free length of the valve springs. Replace the springs if they are…

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – Flywheel, ignition coil, starter motor

Posted on July 6, 2022

a. Disassembly/reassembly Starter motor equipped type: Measure starter performance while cranking the engine. If performance is not within service limits, disassemble and inspect as described…

Komatsu PC-01

Komatsu PC01 – HYDRAULIC EXCAVATOR – Fuel tank, governor arm, control base

Posted on July 5, 2022

a. Disassembly/reassembly  

Posts navigation

Page 1 Page 2 … Page 6 Next Page

Pages

  • CAT Hydraulics Troubleshooting
  • Contact Us
  • Oil & Gas Processes
  • Privacy Policy
  • Terms and Conditions

Recent Posts

  • Hydraulic Proportional – Hyvos simulation analysis
  • Hydraulic Proportional – Axis Worksheet
  • Hydraulic Proportional – Modeling a Cylinder and Valve
  • Hydraulic Proportional – Modeling a Cylinder System
  • Hydraulic Proportional – Modeling a Cylinder

Categories

  • CAT Schematic
  • Contamination and Temperature
  • Control Valve
  • Fluid Flow
  • Hydraulic Accessories
  • Hydraulic Actuators
  • Hydraulic Circuit Design
  • Hydraulic Control
  • Hydraulic Pressure Control
  • Hydraulic Pressure Valve
  • Hydraulic Proportional
  • Hydraulic Schematics
  • Hydraulic Servo
  • Hydraulic Symbols
  • Hydrostatic Transmissions
  • Komatsu PC-01
  • Linear Actuators
  • Mobile Circuits
  • Servo Valves
  • Valve
© Copyright 2023 – Hydraulic Repair Schematic
Wisteria Theme by WPFriendship ⋅ Powered by WordPress