a. Disassembly/reassembly b. Inspection – Oil level switch Check continuity between the yellow and green switch leads with an ohmmeter. 1) Hold the switch in…
a. Disassembly/reassembly – Crankshaft bearing Reassembly: Oil the circumference of the bearing, and install the bearing with the following special tools. – Timing gear/governor drive…
a. Removal/installation b. Disassembly/reassembly c. Inspection – Valve spring free length Measure the free length of the valve springs. Replace the springs if they are…
a. Disassembly/reassembly Starter motor equipped type: Measure starter performance while cranking the engine. If performance is not within service limits, disassemble and inspect as described…
a. Disassembly/reassembly
a. Removal/installation b. Disassembly/reassembly c. Inspection – Float level height Place the carburetor in the position as shown and measure the distance between the float…
a. Disassembly/reassembly b. Inspection – Engine switch (Without oil alert) Turn the switch, and check the continuity between the wire and the fan cover with…
a. Disassembly/reassembly
a. Disassembly/reassembly b. Recoil starter assembly 1) Insert the hook on the outer side of the spring into the groove inside the reel. 2) Pass…
a. Disassembly/reassembly